These systems operate with the ignition switched on. Press or pull the switch to raise or lower a window to the desired height (the rear windows do not open fully); From the driver's seat, use switch: 1 for the driver's side; 3 for the front passenger side; 4 and 5 for the rear passengers. From the passenger seats, use switch 6.
One-touch mode Depending on the vehicle, this mode works in addition to the operation of the electric windows described previously. It is only fitted to the driver's window. Briefly press or pull switch 1 fully: the window is fully lowered or raised. Pressing the switch again stops the window moving. Note: if the window detects resistance when closing (e.g.: branch of a tree, etc.) it stops and then lowers again by a few centimetres.
Operating faults In case of a fault when closing a window, the system reverts to normal mode: pull the switch concerned up as often as necessary to fully close the window (the window will close gradually), hold the switch (still on the closure side) for one second then lower and raise the window fully to reinitialise the system. If necessary, contact your authorised dealer. |
Renault Koleos Service Repair Manual > Non-side opening element mechanisms: Bonnet release cable:
Removal - Refitting
REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the door sill lining (see Front door sill lining: Removal - Refitting) (71A, Body internal trim), the cab floor lining (see Cab floor lining: Removal - Refitting) (71A, Body internal trim), the front wheel arch liner partially (see 55A, Exterior prot ...