Renault Koleos Service Repair Manual: Sill panel closure panel: General description

Renault Koleos Service Repair Manual / Panelwork / Side lower structure / Sill panel closure panel: General description

Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.

Before reading this general information, check that there are no special notes associated with this vehicle.

These special notes will be specified if applicable in other parts of this subsection dealing with the part.

 

Note: For a detailed description of a particular connection, (see MR 400).

I - DESIGN OF THE STRUCTURAL COMPONENT

Side lower structure

This is a basic part; its only function is that of a sill panel closure panel.

II - AREA TO BE CUT FOR PARTIAL REPLACEMENT

Side lower structure

III - ASSEMBLY METHOD FOR A PARTIAL REPLACEMENT

Only the connections which are specific to the partial replacement by cutting are indicated.

WARNING If the mating faces of the parts to be welded are not accessible, make EGW plug welds to replace the original resistance welds (see MR 400).

If there are other issues regarding access to mating faces, the various options are described in the basic instructions for structural bodywork repair (see MR 400).

    Sill panel: Description

    Sill panel closure panel: Description

    See More:

    Renault Koleos Service Repair Manual > Engine and cylinder block assembly: Oil level sensor: Removal - Refitting
    M9R REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift Remove: the front right-hand wheel the front right-hand wheel arch liner II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the oil level sensor connector (1) . Remove the oil level sensor. REFITTING I - REFIT ...

    Renault Koleos Owners Manual

    Renault Koleos Service Repair Manual

    © 2018-2024 Copyright www.rkoleos.com
    0.0052