Renault Koleos Service Repair Manual: C-pillar upper trim: Removal - Refitting

Renault Koleos Service Repair Manual / Trim and upholstery / Body internal trim / C-pillar upper trim: Removal - Refitting

Body internal trim

REMOVAL

I - REMOVAL PREPARATION OPERATION

  • Remove:
    • the rear door sill lining (see 71A, Body internal trim, Rear door sill lining: Removal - Refitting, page 71A-8) ,
    • the C-pillar lower trim (see 71A, Body internal trim, C-pillar lower trim: Removal - Refitting, page 71A-9) .

II - OPERATION FOR REMOVAL OF PART CONCERNED

Body internal trim

  • Open the covers.
  • Remove:
    • the rear seat belt upper bolt (1) ,
    • the bolt (2) ,
    • bolt (3) .
  • Disconnect the connector.
  • Remove the C-pillar upper trim.

REFITTING

I - REFITTING PREPARATION OPERATION

  • Check the condition of the clips and replace if necessary.

II - REFITTING OPERATION FOR PART CONCERNED

  • Connect the supply connector.
  • Refit the C-pillar upper trim.
  • Torque tighten the rear seat belt upper bolt (49 N.m) (1) .
  • Refit:
    • the bolt (2) ,
    • the bolt (3) ,
    • the covers.

III - FINAL OPERATION.

  • Refit:
    • the C-pillar lower trim (see 71A, Body internal trim, C-pillar lower trim: Removal - Refitting, page 71A-9) ,
    • the rear door sill lining (see 71A, Body internal trim, Rear door sill lining: Removal - Refitting, page 71A-8) .
    B-pillar trim: Removal - Refitting

    Rear end panel lining: Removal - Refitting

    See More:

    Renault Koleos Service Repair Manual > Exterior protection: Rear side door protective strip: Removal - Refitting
    REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Heat the edges (1) of the rear door moulding using a heating gun. Note: Make sure that the body is not damaged. Protect the door rabbet using masking tape. Unclip the rear section of the moulding (2) by pulling the lever arm using the tool (Car. 1597) ...

    Renault Koleos Owners Manual

    Renault Koleos Service Repair Manual

    © 2018-2022 Copyright www.rkoleos.com
    0.006