The RENAULT card must be inserted in detection zone 1. To start:
Special features
"Hands-free" starting with the tailgate open In this case, the RENAULT card should not be located in the boot, to avoid any risk of loss.
Accessories function (switching on the ignition) Once you have gained access to your vehicle, you may use some of its functions (radio, navigation, wipers, etc.). To use the other functions, with the RENAULT card in the passenger compartment, press button 2 without pressing the pedals.
Operating faults In certain cases, the RENAULT "handsfree" card may not work:
The message "Place card close START and push" appears on the instrument panel. Depress the brake or clutch pedal, then place the RENAULT 3 card (logo side) in contact with the start button 2 for around 2 seconds. Press the 2 button to start the vehicle. The message goes out.
Conditions for stopping the engine The vehicle must stationary, with the lever positioned in N or P for vehicles with an automatic transmission. With the RENAULT card in the vehicle, press the 2 button: the engine will stop. The steering column is locked when the driver's door is opened or the vehicle is locked. If the RENAULT card is no longer in the passenger compartment or if the card battery is low when you try to switch the engine off, the message "No key-card Press and hold" appears on the instrument panel: press the button 2 for longer than two seconds. If the card is no longer in the passenger compartment, make sure you can retrieve it before pressing and holding the button. Without the RENAULT card, you will not be able to restart the vehicle. With the engine switched off, any accessories being used (radio, etc.) will continue to function for approximately 10 minutes. When the driver's door is opened, the accessories stop working.
Remote engine start-up Activation If the vehicle is equipped with it, press the unlocking button 4 briefly, in a duration lower than 5 seconds, then press the remote start button 3 twice for about 3 seconds each time. If there is a problem, consult an approved Dealer as soon as possible. Operation This function allows to remote starting of the engine. To do this, press the locking button 5, followed by the remote start button 3 for about 3 seconds. Flashers turn on about 3 seconds.
This function also allows to program the engine to start, in order to heat or ventilate the passenger compartment up to 24 hours before using the vehicle. The level of heat comfort (temperature, defrost) set up before the setting the program. Depending on the country, the engine will be running during 5 or 10 minutes. Once the engine started, it will be possible to add additional 5 or 10 minutes by pressing again the remote start button 3. Depending on the vehicle, the configuration and the programming are done using the multimedia display 6. Refer to the multimedia instructions for your vehicle. The range for the remote engine start-up varies according to the surroundings:
The remote engine start-up operates:
If one of the conditions is not respected, flashers will turn on during approximately 3 seconds. Note: In some rare case, the engine can be stopped just after engine start by remote engine start-up. In this case, remote engine start-up is available and driver can try to use again. If the engine is stopped continuously, consult an approved Dealer as soon as possible.
|
Renault Koleos Service Repair Manual > Air conditioning: Pressure relief valve -
compressor connecting pipe:
Removal - Refitting
M9R, and AIR CON 01 or AIR CON 02 IMPORTANT To avoid any risk of damaging the systems, apply the safety and cleanliness instructions and the operation recommendations before carrying out the repair. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towin ...