Renault Koleos Service Repair Manual: Rear bumper: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

  • Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

II - OPERATION FOR REMOVAL OF PART CONCERNED

Exterior protection

  • Remove the clips (1)

Exterior protection

  • Remove the bolts (2) .

Exterior protection

  • Remove the clips (3) .

Exterior protection

  • Remove the rear bumper partially.
  • Disconnect the various connectors (according to the equipment level).
  • Remove the rear bumper (this operation requires two people).

REFITTING

I - REFITTING PREPARATION OPERATION

  • Connect the various connectors (depending on equipment level).

II - REFITTING OPERATION FOR PART CONCERNED

  • Position the rear bumper (this operation requires two people).
  • Refit:
    • the clips (3) ,
    • the bolts (2) ,
    • the clips (1) .

III - FINAL OPERATION.

  • Carry out a function test on the proximity radar.
    Front bumper: Stripping - Rebuilding

    Rear bumper: Stripping - Rebuilding

    See More:

    Renault Koleos Service Repair Manual > Engine and cylinder block assembly: Oil pressure: Check
    M9R WARNINGAlways check the oil level using the dipstick. Do not exceed the maximum level on the dipstick (could destroy the engine). Correct the engine oil level if necessary before delivering the vehicle to the customer.   Note: When topping up the engine oil, always leave at least 10 minutes ...

    Renault Koleos Owners Manual

    Renault Koleos Service Repair Manual

    © 2018-2024 Copyright www.rkoleos.com
    0.0054