Renault Koleos Service Repair Manual: Tyre pressure monitor: List and location of components

TYRE PRESSURE SENSOR

Tyre pressure monitor

The system is made up of:

four pressure sensors built into the valves (one per wheel); they transmit a radio frequency signal,
four tyre pressure monitor receivers, for the purpose of receiving and decoding the sensor signals and transmitting them to the UCH,
a computer that receives, decodes and processes information from the receivers, and then determines which message to display,
a display integrated into the instrument panel.

Note: The position of the sensor on each wheel is automatically identified by the UCH computer.

Tyre pressure monitor

Composition of the pressure sensor:

Tyre pressure monitor: Precautions for the repair

I - CLEANLINESS

Clean the bearing faces on the tyre pressure monitor valve.

II - GENERAL RECOMMENDATIONS

Do not swap the wheels if they have been removed.

WARNING Hold the sensor in position on the wheel to prevent it from turning during tightening.

WARNING To avoid any damage to the sensor, make sure the tyre bead never presses on the sensor.

Renault Koleos Service Repair Manual > Engine and cylinder block assembly: Crankshaft seal, gearbox end: Removal - Refitting
M9R IMPORTANTConsult the safety and cleanliness advice and operation recommendations before carrying out any repair operation. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift. IMPORTANTTo prevent the vehicle from falling, lash it to the vehicle lift using a strap. D ...

Renault Koleos Owners Manual

0.0068