Renault Koleos Service Repair Manual: Bulkhead: General description

Renault Koleos Service Repair Manual / Panelwork / Front upper structure / Bulkhead: General description

Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.

Before reading this general information, check that there are no special notes associated with this vehicle.

These special notes will be specified if applicable in other parts of this subsection dealing with the part.

Note: For a detailed description of a particular connection, see MR 400.

I - DESIGN OF THE STRUCTURAL COMPONENT

Front upper structure

This is a basic part; its only function is that of a bulkhead.

II - AREA TO BE CUT FOR PARTIAL REPLACEMENT

Front upper structure

Cutting line (1) shows the area in which it is possible to carry out a partial replacement.

III - ASSEMBLY INSTRUCTIONS FOR A PARTIAL REPLACEMENT

Only the connections which are specific to the partial replacement by cutting are indicated.

If there are other issues regarding access to mating faces, the various replacement options are described in the basic instructions for structural bodywork repair (see Connections for partial replacement edge-to-edge: Description) .

Front upper structure

The line (2) on the drawing shows a butt weld made by continuous GMAW welding.

Dashboard cross member: Removal - Refitting

Bulkhead reinforcement: Description

See More:

Renault Koleos Service Repair Manual > Fuel mixture: Air flowmeter: Removal - Refitting
M9R REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the connector from the air flowmeter. Remove: the air filter unit air flowmeter bolts (1) , the air flowmeter, the air flowmeter seal. REFITTING I - REFITTING PREPARATION OPERATION Always replace the air flowmeter seal. II - REFITTING OP ...

Renault Koleos Owners Manual

Renault Koleos Service Repair Manual

0.0057