Renault Koleos Service Repair Manual: Tyre pressure monitor computer: Removal - Refitting

Renault Koleos Service Repair Manual / Chassis / Tyre pressure monitor / Tyre pressure monitor computer: Removal - Refitting

TYRE PRESSURE SENSOR

REMOVAL

I - REMOVAL PREPARATION OPERATION

  • Remove the lower cover of the driver's side dashboard (see Dashboard: Removal - Refitting) (MR 393, 57A, Interior equipment).

II - OPERATION FOR REMOVAL OF PART CONCERNED

Tyre pressure monitor

  • Remove the bolt (1) .
  • Disconnect the connector (2) .
  • Remove the tyre pressure monitor computer.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

  • Refit the tyre pressure monitor computer.
  • Connect the connector.
  • Refit the tyre pressure monitor computer bolt.

II - FINAL OPERATION.

  • Refit the lower cover of the driver's side dashboard (see Dashboard: Removal - Refitting) (MR 393, 57A, Interior equipment).
    Tyre pressure monitor: List and location of components

    Tyre pressure monitor receiver: Removal - Refitting

    See More:

    Renault Koleos Service Repair Manual > Exterior protection: Rear side door protective strip: Removal - Refitting
    REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Heat the edges (1) of the rear door moulding using a heating gun. Note: Make sure that the body is not damaged. Protect the door rabbet using masking tape. Unclip the rear section of the moulding (2) by pulling the lever arm using the tool (Car. 1597) ...

    Renault Koleos Owners Manual

    Renault Koleos Service Repair Manual

    © 2018-2025 Copyright www.rkoleos.com
    0.0059